LSI/3Ware 9650SE-2LP SATA2 Hardware RAID Controller Kit

Specification
• Mfr Part Number: 9650SE-2LP KIT
• Features:
• 8th-generation StorSwitch non-blocking switched architecture
• On-board I/O RISC processor and RAID offload provides true hardware RAID: SCSI device driver model to take advantage of the benefits of SCSI using inexpensive Serial ATA drives
• Bootable array support for greater fault tolerance
• Variable stripe size for performance tuning by application
• 64-bit LBA support
• ATA pass-through mode support
• 128MB DDR2-533 memory with ECC protection
• 32 pooled DMA channels
• Complete configuration management suite:
• 3ware BIOS Manager 2 (3BM2) - easy to use BIOS configuration tool
• 3ware Disk Manager 2 (3DM2) - browser-based management tool
• Command Line Interface (CLI) - scriptable configuration tool
• SNMP support
• SMTP support for email/pager notification
• ATA/6 and Out of band (OOB) staggered drive spin-up support
• Auto carving allows LUNs > 2TB to be divided into multiple units for legacy operating systems limited to 2TB max. per LUN
• Multiple logical unit sizes and RAID levels on one card
• Multiple card support within a system for large storage requirements
• Hot-swap and hot-spare support for data availability
• Dynamic sector repair for robust data protection
• S.M.A.R.T. disk drive monitoring for reliability
• Emergency Flash Recovery protects against failed firmware upgrade
• Drive activity LED support
• Online Capacity Expansion and RAID Level Migration
• Enhanced data protection with write journaling for non-redundant arrays and accidental drive removal
• Drive insertion and removal notification
• Array/Drive Status and drive identification LED support (requires 3ware Chassis Control Unit-enabled backplane)
• Chassis Control Unit for enclosure management via I²C
• Form Factor: Low Profile
• Port: 2x SATA, 2.6 Specification support
• Host Interface: PCI Express x1, PCI Express 1.1 compliant
• Raid Levels: 0, 1, Single Disk, JBOD
• Onboard Memory: 128MB DDR2-533
• Connector Type: Discrete
• BBU Support: No
• BIOS PnP (plug and play) and BBS (BIOS boot specification) support
• Power Requirements: 18W maximum
• Dimension (LxH): 7.3 x 2.73 inch / 18.54 x 6.93 cm

* Product descriptions and part numbers are subject to change, and may not reflect manufacturer product changes. Please check the manufacturer's website and use the item's manufacturer part number to find the most up to date product description.